Daniel Cretul
Reviewed in the United States on 8 April 2021
Good tuff motors
Used in a couple of brushless trucks. The ESC could be better but works fine out of the box.
5.0
۲۶٬۸۰۷٬۰۰۰ تومان
خرید موتور براشلس ضد آب ۳۶۵۰ ۳۵۰۰KV GoolRC از میکرولس. [مشخصات فنی] ★کت و شلوار برای ماشین RC در مقیاس 1/10. (توجه: این محصول استفاده از باتریهای 2S (7.4 ولت) را برای دستگاه توصیه میکند. استفاده از
GoolRC Upgrade Waterproof 3650 3500KV Brushless Motor with 60A ESC Combo Set for 1/10 RC Car Truck
وزن
0.31 کیلوگرم
★کت و شلوار برای ماشین RC در مقیاس 1/10. (توجه: این محصول استفاده از باتریهای 2S (7.4 ولت) را برای دستگاه توصیه میکند. استفاده از باتری نامتناسب ممکن است منجر به سوختن وسایل الکترونیکی شود.) ★ قطر شفت 3.175 میلی متر، طراحی موتور 4 قطبی 12 شیار با گشتاور بالا. سیم پیچ های مسی با خلوص بالا کارایی را به حداکثر می رساند. ★ ویژگی های حفاظت چندگانه: حفاظت از قطع ولتاژ پایین، حفاظت از گرمای بیش از حد، حفاظت از دست دادن سیگنال دریچه گاز. ★ولتاژ در 5.5V/3A BEC.
قیمت :
فروشگاه :
وزن
0.31 کیلوگرم
★کت و شلوار برای ماشین RC در مقیاس 1/10. (توجه: این محصول استفاده از باتریهای 2S (7.4 ولت) را برای دستگاه توصیه میکند. استفاده از باتری نامتناسب ممکن است منجر به سوختن وسایل الکترونیکی شود.) ★ قطر شفت 3.175 میلی متر، طراحی موتور 4 قطبی 12 شیار با گشتاور بالا. سیم پیچ های مسی با خلوص بالا کارایی را به حداکثر می رساند. ★ ویژگی های حفاظت چندگانه: حفاظت از قطع ولتاژ پایین، حفاظت از گرمای بیش از حد، حفاظت از دست دادن سیگنال دریچه گاز. ★ولتاژ در 5.5V/3A BEC.
بر اساس نظرات آمازون
نظر شما میتونه به بقیه کمک کنه تا انتخاب بهتری داشته باشن خوشحال میشیم اگر تجربه تون از این محصول رو با ما به اشتراک بذارید!
نمایش ۵ نظر آمازون از ۲۱۴ نظر
Good tuff motors
Used in a couple of brushless trucks. The ESC could be better but works fine out of the box.
Cool RC brushless esc / motor combo.
I purchased this to upgrade a wltoys 12428. This Cool RC set is a brushless set just a FYI. I knew that when I got it. The shaft for the motor is the same size as the stock. This was a upgrade that i wanted to do and go brushless and have a more standard setup so i dont have to wait 4-8 weeks for parts from over seas. The motor bolts up to the stock holes on the mount. The shaft is the same size so i just swapped the gear over. I looked all over the listing completely before and after i got the set. I feel I was completely ripped off and completely mislead. No where does it say the start off / punch will only be 25% MAX so you pull the trigger and it does what is called coggin. This mainly happens on grass it can take 4-15 secs before it decides to take off. On hard surfaces it has 1 to 5 sec delay. The esc is crap it's not defective it is built that way. I did get a programing card and tried to adjust it and then max it out in the end. As again on grass it is crap on take off when coggin. On hard surfaces it will do wheelies many times after the hugh delay. Everything in this car is upgraded, the servo, motor, esc and the receiver and transmitter. I knew that i would be doing a lot of modding on the car and I did. The on / off switch was moved to the side of the body from the bottom, the lights were modified as well. I had to change the plugs and solder them together and then heat shrink. These cars came with a combo esc / receiver. I had to get very creative to put the motor, esc, receiver in the same spot as 2 parts, re-wire etc. I don't know about replacement/ refund cuz i had to splice wires for the esc, and switch. That part is no big deal, i have been doing board level repairs, dc jacks, etc along with being in IT from server's, laptops, desktops, plotters etc for 30 years and almost all is self taught along with school / college. The car as a whole functions and runs. The motor has a good amount of torque and is smooth. I was hesitant on using Cool RC instea
great product!!
using 2s 60000mah 50c battery worked perfect after about 6 times so far still pushing hard no problems just a bit of lag at 1st when throttling but most likely due to the programming compared to transmitter, that i'm sure the program card can fix, which I did not buy. I think I spent my money well!
Sub par quality unless you wanna temporary BL
It's ok if you want a mild brushless system because you wanna try brushless. It's a bit clanky and delayed when it starts moving but once it gets rolling it is a noticeable difference from brushed . It gets hot fast I wouldn't rely on the kv rating stamped on the can. . If you wanna try brushless on a budget go for it. If you want top shelf quality go with castle creations. Oh I ended up using my hobby wing esc with the motor and that helped a lot
Goolrc ESC and Motor combo
Works great just would definitely make sure you also buy the goolrc program card cause without that I could get it to go forward at 100% power it was only at 50% power