Mike
Perfect experience
Perfect for Beginners, Highly Recommended! I’m a total newbie—this is my first time buying and using a laser engraver. After using it for a few days, I have to rave about the shock and delight this Swift 7W has brought me! I’ll share my experience and advice for newbies from the following aspects: First off, it’s extremely easy to set up. From unboxing to assembly, it took me less than five minutes. It’s basically divided into four parts, all of which are pre-assembled. I just needed to put these four parts together. After connecting the X and Y axes, I simply attached the guide rails and laser module to finish. Of course, the manual also includes very detailed installation steps. In short, the setup was super simple for me! Second, it’s incredibly easy to operate. I controlled it via my laptop. After plugging in the laser engraver, I connected it to my computer with a USB cable, then downloaded the AtomStack Studio software as instructed in the manual. What’s great is that this software is not only free of charge but also comes with tons of finished templates for engraving and cutting. For example, if you like a certain design, you just need to use it with one click—all parameters are pre-set. You only have to confirm and start engraving; even the focusing is already adjusted. I found it so newbie-friendly! My first project was engraving a Santa Claus pattern on a wooden board, and it turned out perfectly. In addition, there are multiple operation methods. Later, I also tried controlling it via a smartphone app, which was very convenient and simple! Finally, I want to say that I can now use the Swift 7W engraver proficiently. Christmas is right around the corner, and I plan to get their upgraded Swift 12W model to unleash more of my imagination. All the above are my true experiences and feelings—you can refer to them. I highly recommend the AtomStack Swift series. It’s extremely versatile and practical!!